48 Volt (14S) Nissan Leaf KIT

This kit is used along with 7x Nissan Leaf Gen 1/2 OR 4x Nissan Leaf Gen 3/4 batteries to make a 48V (14s) battery. For Leaf Gen 3 batteries you can use 7 modules and 2 kits in parallel.

Note: When ordering make sure you purchase the right kit. Gen 1/2 and Gen 3 are not compatible. Even though the terminals are identical the Positive and Negative terminals are reversed on Gen 3.

No soldering required, can assemble in 5 minutes.

Kit Includes

Gen 1/2

• Bottom PCB (Power board)
• Center PCB (Holds BMS, Fuses, Connector)
• Top PCB (faceplate with voltage screen)
• 4x 20mm standoffs
• BMS (14s, 40 Amp, bluetooth, Xiaoxiang app)
• Voltage display screen (green)
• XT90 Connector
  
• 2x Aluminum handles
• 4x steel rods to hold 7x Nissan Leaf batteries
• 8x screws

Gen 3/4

• Bottom PCB (Power board)
• Center PCB (Holds BMS, Fuses, Connector)
• Top PCB (faceplate with voltage screen)
• 4x 20mm standoffs
• BMS (14s, 40 Amp, bluetooth, Xiaoxiang app)
• Voltage display screen (green)
• XT90 Connector
  

** Nissan Leaf batteries are not included.

Instruction Video Video

 WARNING. The screws you use on the bottom PCB are electrically active, DO NOT place anything conductive on them, you will short the battery.